Yet, no oil leak before you went in!

 

lol you gonna drive me crazy lol yes I know your right but the spot where you mentioned I put a brand new gasket there so I guess the dye will show us where the leak and I’ll make sure to post it here to show you as well lol

 

God damn hammerz you were right!!! The leak coming from the crank shaft pully . You think it’s that gasket you told me about ? I swear I put a new one before installing it

 

does the front cover have to be removed to install that cus I knew there is a gasket that goes into the timing cove and there is one that actually goes into the crankshaft pully they both new and the most newest one is the one

I put this one https://www.partsgeek.com/kgc6qwx-hu...wqjHAetMk_IxLy

it’s not this one right ?

 

did you notice if the nose of the crankshaft has a bit of a groove in it where the seal rides? if so the groove is not supposed to be there and you might need a special seal to repair that. i guess its a bit tighter on the crank.

 

Problem fixed thanks for hummerz and everyone who helped out ! The problem was the damn front main crank seal. When I took off the pully I think for some reason it wasn’t pushed all the way in I don’t know how that happened but anyway I took it off and installed a brand new one , made sure it’s all in and put a new washer into the pully and installed everything. Went on a little drive and came back and checked with light and UV light since I have a dye In the oil and there was none and the front cover is dry. I am gonna highway test it tomorrow but I think she is finally good to go