Unable to remove center of 5 rear cabin roof clearence lights for bulb replecement. Obviuos;y a gasket sealing light and cab. Supposedly a notck/clip to facilitate removal. Is this actuator on the front vehicle side or rear vehicle side of light? Does the lens lift off first, if so front or rear of lens? Thanks. Local law enforcement rung me up on Labor Day Saturday pm for faulty equipment, seriously think ust looking fro excuses to assess drivers on a holiday. Thanks OCFDfyrfytr

 

I would fight the ticket. Clearance lights are not mandatory on an H3.

I have never removed the light covers. Maybe someone who has can assist.

 

Law-enforcement advise if it came on factory it must work as factory delivered.

 

Thanks for all the terrific assistance on the clearance bulbs on my H2 in the rear header

 

Directions needed. RNR of rear shocks, non-airbag suspension, on my 2000 H2. By the way I love this forum, blog on to motorcycle forms and have yet to get the assistance in detail as I do on this forum. Thank you all

 

Welcome to HF.

This section is NOT for tech questions. https://www.hummerforums.com/forum/n...questions-116/

I see you already started a thread over in the H2 section for your questions, that is where they go. We also frown on duplicate threads, ask your question once and everybody is happy.

 

Didn't see it was an H2. They are required to work due to the width.

 

The DOT law states all original equipment must work.
Any vehicle over 80 inches in width requires a three bar ID light in the center. H2 is about 81" or so.