Hey guys was hoping someone would know the answer to this. I just put the 7inch led lights on my H3 and somehow my high beams turn on low beams and low beams turn on high beams what did I do wrong?

 

Welcome to HF.

Made your connections backwards?

 

Uhhhh, Ummmmm, DUH! Sounds like you wired the lights incorrectly.

 

Did you use an adapter harness to switch the high/low polarity? Most LEDs use a common ground and switch the positive side input to go between high and low beam. The H3 wiring does the opposite and switches the ground side. An adapter harness with a relay is required to swap the polarity. They can be picked up in Amazon for not too much.

Detailed video here about converting to LEDSs

https://m.youtube.com/watch?v=SKi2cz2h6lE

 

The wiring harness only goes on one way.

 

Post pics of the connector contacts/wires. It appears China reversed wires to the connector. Seen it many times over the years.