Ok I found a remanufactured engine in a crate. It looks great and I think I’m ready to pull the old one out. Can anyone recommend any steps that I should be taking when I do this swap out. I just wasn’t sure if there was something else I should be aware of. I’ve swapped out engines before in fords that’s it. And that was years ago when it could be done in half a day. Also if I should be changing anything else out. Since I’ve gone this far. Any suggestions would be appreciated

 

I have a suggestion..... post ALL your H3 questions in the H3 section. I moved this from the HF Help & Suggestion Center section because ... as the sticky thread at the top of that section says...
HF Help & Suggestions Center is for questions on how to use the forum features here.... has zero to do with any vehicle.

Note the vin# of the new motor, you will need to program that into the PCM eventually. While in there look at the motor mounts, might be time for fresh ones.

Good luck.