factory wheel arch trim
Thread Starter
|
Member
Joined: Jan 2015
Posts: 74
From: Toronto, Ontario
factory wheel arch trim
My 03 has the factory wheel arch plastic trim, over the years it has started to slowly move away from body panel (guessing rusting at bottom)...
Anyone used a trim piece or "caulking", or ??? to seal the gap?
Would this slow growth of further rust at base (due to being sealed from above)?
gap goes from basically stock/tight to about 10mm at widest, varies per wheel and point of wheel arch.
Honestly think caulking would be the easiest and cleanest looking?
Just gotta find me some big black caulk sealant
Anyone used a trim piece or "caulking", or ??? to seal the gap?
Would this slow growth of further rust at base (due to being sealed from above)?
gap goes from basically stock/tight to about 10mm at widest, varies per wheel and point of wheel arch.
Honestly think caulking would be the easiest and cleanest looking?
Just gotta find me some big black caulk sealant
Last edited by XLRH2; Sep 24, 2024 at 06:30 PM.
Thread
Thread Starter
Forum
Replies
Last Post