PRIVATE For Sale / Trade Classifieds Sell/Trade your stuff for free! NO COMMERCIAL POSTS!

Oil Change Question

Thread Tools
 
Search this Thread
 
Old Jul 27, 2012 | 07:01 PM
  #1  
DaWgPoUnD's Avatar
Thread Starter
|
Member
Joined: Jan 2012
Posts: 51
From: South Carolina
Default Oil Change Question

2008 H3X

Changed the oil/filter today in my H3 and drained a little more than 5 qts out (truck on ramps so maybe left some old in back side of pan?) Anyway, put 6 qts in of which added the last 3/4 of a qt after checking stick and looked about 1 qt low. After letting is sit for a while checked stick again and it looks to be about 1/4 qt over fill (above the full mark). Is there an "over fill" limit or such that if you over fill to a limit that will put to much pressure on seals? I am curious before I over react and pull the plug and drain some of it back out?

Thoughts?

Thanks in advance
 
Old Jul 27, 2012 | 07:28 PM
  #2  
2wheelmonster's Avatar
Senior Member
Joined: Jan 2009
Posts: 1,439
Default

well I've never had an issue with it being over full that much. I would say a full quart might be pushing it. worst case scenario, drive it down the highway full throttle for an hour straight and that should burn off 1/4
 
Old Jul 27, 2012 | 09:17 PM
  #3  
carloscrx101's Avatar
Member
Joined: May 2012
Posts: 43
From: Tampa,Fl
Default

Fill to what Is recomended over fill is not good for oil control pistons rings to much oil makes the rings to not work properly after so many times that u over fill u motor they create some hard oil gunk on the rings and motor will smoke blue (exhaust) it takes more that one over fill for this to happen but if it is my car I just get the oil out to the right amount..good luck
 
Old Jul 28, 2012 | 10:41 AM
  #4  
Xlr8n's Avatar
Senior Member
Joined: Oct 2011
Posts: 378
Default

Drain completely. Tilt the vehicle with a jack if needed to get all the old oil out. Add six quarts with a new filter and run it for a bit. Observe where the new oil level is on the dipstick. Scratch a permanent line at that point. That is now your accurate 'full' line. I trust knowing the engine requires 6 quarts before I trust the premade lines on a manufactured dipstick.
 
Old Jul 28, 2012 | 10:47 AM
  #5  
happythree's Avatar
Senior Member
Joined: May 2012
Posts: 2,005
Default

I drain on the level,no need for ramps, i never measured how much came out, new filter and 6 qts, it reads a little high.
I dont sweat it, they call for 6 and thats what i use.

I DEFINETLY WOULD NOT DRIVE AT FULL THROTTLE,, ANYWHERE, ANYTIME. ITS NOT A FIX!!
 
Old Jul 28, 2012 | 11:17 AM
  #6  
carloscrx101's Avatar
Member
Joined: May 2012
Posts: 43
From: Tampa,Fl
Default

Agree on last post 100%
 
Old Jul 28, 2012 | 03:42 PM
  #7  
bosoxdew's Avatar
Member
Joined: Oct 2011
Posts: 56
From: Homestead, FL
Default

I completly agree with happythree.....DO NOT DRIVE FULL THROTTLE.
 
Old Jul 28, 2012 | 03:51 PM
  #8  
DaWgPoUnD's Avatar
Thread Starter
|
Member
Joined: Jan 2012
Posts: 51
From: South Carolina
Default

Drained and refilled on level. All is good now. Thanks for the responses.
 
Old Jul 29, 2012 | 11:17 AM
  #9  
bosoxdew's Avatar
Member
Joined: Oct 2011
Posts: 56
From: Homestead, FL
Default

Glad to hear it worked out for you
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
rhill20
PRIVATE For Sale / Trade Classifieds
8
Jul 1, 2013 12:23 PM
drtom
PRIVATE For Sale / Trade Classifieds
4
Jan 17, 2011 09:23 PM
hummer07
PRIVATE For Sale / Trade Classifieds
5
Nov 18, 2008 10:46 AM
hummer1
PRIVATE For Sale / Trade Classifieds
16
Jul 7, 2007 07:16 AM
CDiPrecision
PRIVATE For Sale / Trade Classifieds
0
May 27, 2007 01:22 PM




All times are GMT -5. The time now is 12:13 AM.