When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Use existing front tow hooks to hook to ?Blue Ox? or similar systems
Hummer H3For the Hummer driver who wants the rugged look and off road capabilities of the Hummer, but in a smaller size and with a more fuel economy friendly engine.
Whats the purpose of this? To tow the H3?
if so, keep in mind you need to set the T-case (not the transmission) into neutral before towing it as to not risk damaging the transmission.
The D Ring attachment points ARE the frame. As you can see below the "horns" the D rings mounts to are part of the H3/H3T frame end.
Not sure I've ever seen any other way of flat towing an H3.
I'm always leary of the metal plates at the end of the horns where the d ring bolt to. I've looked there and the welds are poop and the metal pretty thin.
I tow my 3 behind my motorhome, bar mounts to frame, not tow hook part. I will get a pic for you.
did you pay approx 400 dollars for the cross-member type mount that mounts on both sides? Is it supposed to provide more strength or was it simply made for the other vehicle that shared this frame but didn’t have the hummer tow hoooks?
Super easy to tow, it actually shows you the 2 buttons on dash to get into N. Then put tranny in P and off you go, of course make sure the 3 is hooked up before performing these actions
Use existing front tow hooks to hook to “Blue Ox” or similar systems
