I am sure this has been done but I can't figure it out. I am looking to put a USB and A/V jack inside of the center console box and run the wire to my radio but I can't seem to be able to remove the console so that I can drill the hole in the console box for the mount and screw it in place from the backside and run the wire up to the radio. Any help would be appreciated.

 

It is easiest with the front seats removed. 4 bolts and a couple wire connectors each seat.

 

May be better to route along the side under the door sill.

Then under the seat and up thru console.

 

If you haven't used either of the blanks in the center dash panel you may want to put it there. There are two blank spots that can be easily made larger with a dremmel. Much easier to remove and work on.

 

TY...Will look into that