One Headlight Dim
Thread Starter
|
Junior Member
Joined: Jun 2023
Posts: 5
Time to check continuity and voltage drop for each of the headlight wires. Individually lol. Back probe each wire at the light socket (the back of the light housing) and then connect the other end of the probe at the fuse or the Relay respectively. I'm guessing you got the green crustie growing.
The new wire had a black on the edge. So I assumed Ground. Turns out ground is the middle. I have it hooked up correctly now.
Do I need to take a battery terminal off or let it reset somehow? I assume there is a protection mode?
Senior Member
Joined: Dec 2019
Posts: 193
If you still have your extra ground installed, you need to remove it. This system needs to work with a floating ground on the circuit not being used (low beam or high beam). Take a look again at the schematic, specifically on the relay I mentioned (relay 70).
Thread
Thread Starter
Forum
Replies
Last Post
ski.dive
Hummer H3
0
Feb 18, 2019 08:51 AM
surftrish
PRIVATE For Sale / Trade Classifieds
21
Jan 3, 2007 01:07 AM
