I have a 5 speed manual transmission .only 700 mile on itt ................when i shift 1st shift into 2-nd (btw 2500rpm-3000rpm) making a noise like vibrating some pice of metal or something and it's happening the same thing btw 2-nd----and 3-rd shift (btw 2500 rpm --3000rpm).........btw 3rd-4th..shift.............and 4th-5th shift i don't hear any sound .......i .put in neutral and i accelerate 4000-5000rpm the engine sound it's ok ..only happening when i drive ............................i'm very upset ............anybody knows anything about this problem

 

Odds are it is a heat shield on the exahust somewhere. Why not take it back to the dealer and have them look at it?

 

I have a 2007 H3 with a 5-speed, and it's worst shirting manual trans I have ever owned (new car wise). It has a slight clash when shifting from 1st to 2nd and 2nd to 3rd... it only has 3,800 miles and has been like that since new. It's not horrible (not bad enough to take back to the dealer), but it's a pretty poor shifting vehicle. I hope someone comes out with a short throw shifter for it... but I doubt it due to the low production #'s the 5 speed makes up.

 

Today i went to the dealer .....2 tehnician drive my car .....they don't know from where it's coming the shifting noise ......they pull up my car , i was there in the service whit them , we checkt evry piece of exhaust or metal ......................no exterior noice we found ..i think the noise.it's from interior ......i don'd know what to doo ......return the car or what it's the solution ...........it's unbelievable ........what it's going on in this H3

 

Tell them to keep the vehicle for a few days and drive it and to put you in a loaner. If it's interior, it shouldn't be to hard to find. If it's realted to the powertrain, they should put some chassis ears on it when they drive so they can isolate the noise.