We recently replaced a brakes on our 2009 H3 On the front end only did brake pads on the back end we had to replace brake pads rotors and calipers. Now all of a sudden it has a very bad vibration at around 2500 RPMs. When I press the clutch in the vibration stops. Then when I shift gears and get back to 2500 Rpms it starts vibrating again. Anyone have a clue what this may be?

 

https://www.freeasestudyguides.com/m...h-chatter.html

 

Whenever you ask a question, you should include miles on the vehicle.

 

did you clean the axel faces when you put the new rotors on? maybe the new rotors are not flush on the axel because of rust or debris. or the back of the rim face might not be flush to the rotor same thing check for rust or debris. torque the lug nuts to spec.

 

did you bold and torque all nuts /screws well?