Hi, I have the two codes p0106 and p0301. I've r&r'd the intake manifold and gaskets, swapped coil packs, spark plugs, injectors, just changed the timing chain out prior to these codes after the truck has been sitting for a year and a half. Any advice or experience seeing these two with all those items checked?

 

Did you reconnect the map sensor?

 

Yes cleaned reinstalled map, cleaned intake and ports while I was at it too no change.

 

Check the wires to the map connector, failures reported occur within inches of the connector.

 

Whats the best way to check with no multimeter and poor electronic skills or is a multimeter required

 

Two out of three are not showing continuity so hunting for the breaks

 

Eyeballs.

 

Disregard wires check out going to swap the map

 

Swapped map now p0300 only

 

Jesus disregard again now p0106 is back with p0300