Winch for H2
#3
Win h fie H2
So the least expensive way would be the Badlands XZXR 12000 m. Cost approx. $350. Receiver hitch $75.00 attach to front receiver. The only Warn winch’s that can be mounted in the warm receiver hitch are the 104 series Warn’s. The two winch’s are approx. $1500 each and the receiver mount plate approx $500. I will go with the Badlands winch
#4
What you’re doing is exactly what I did. I used a badlands winch with the badlands hitch adapter.
A few things to note:
- you have to drill a hole vertically in the hitch adapter for a vertical pin. The front receiver on the h2 uses a vertical pin as apposed to the horizontal on on the rear and the adapter mount.
-the front receiver is only rated for 9k lbs so I went with the 9500lb badlands winch to match what was included in the warren kit. It has been more than plenty in my experience l. If you need more power you can always ****** block it.
-make sure you have a battery cutoff for the winch as it draws power when not in use. I also used a set of Anderson connectors to make removing the winch easier.
A few things to note:
- you have to drill a hole vertically in the hitch adapter for a vertical pin. The front receiver on the h2 uses a vertical pin as apposed to the horizontal on on the rear and the adapter mount.
-the front receiver is only rated for 9k lbs so I went with the 9500lb badlands winch to match what was included in the warren kit. It has been more than plenty in my experience l. If you need more power you can always ****** block it.
-make sure you have a battery cutoff for the winch as it draws power when not in use. I also used a set of Anderson connectors to make removing the winch easier.
Thread
Thread Starter
Forum
Replies
Last Post