Yea man, I have video on tools as well. Die Grinder , angle grinder, wheel grinder. Tools, Eastwood spray paint and paint about $1,000 to do it right. Good time to upgrade u joints, fuel pump and trans module.

 

A

needle scaler

needle scaler

speeds up the process.

 

great video Brunob00

 

another thing I plan on doing is removing the top rack and plastic as well as the lower bottom trim/ plastic and brush on encapsulator 2-3 coats then maybe a coat of paint ( bottom) on the top 2-3 coats of encapsulator like I said but when its all good and dry I'll probably cover the sealer with a tape called Zipp tape ( its used on construction sites ) and when its on - its on there ! and its smooth so dirt etc should run off . its the best tape Ive ever seen and also holds up to heat - It can be used to seal seams under tin roofs so should hold up pretty well

 

yea that’s it, check out my playlist for rust