i could really really use two of those retainers right now!!!

 

Congrats with the success of selling this on ebay! Great people making these unobtanium parts!! The shifter button is also a weak spot.-someone was also making a replacement for that.

 

here is the file for the shift button for the H2 if you have or a friend has a 3d printer
https://www.thingiverse.com/thing:246483
they also have the door panel clips
https://www.thingiverse.com/thing:4099562
https://www.thingiverse.com/thing:4099571

 

If there is interest in the shifter button linked above, I could print some up and out them on my eBay store (the file license allows this). I will be making my clips this weekend so once my inventory is restored, I can run a few of these off as well.

So far, I have sold over seventy of my clips with no negative feedback. If anyone on here has purchased them, I would like to hear your experience or even suggestions for improvement if needed.

03-07 HUMMER H2 Sun Visor Retainer

 

Hello all,

I am looking for part number 16 and 17 in the diagram. Anyone can help?

 

I would like to put on the list a Rocker Panel switch plate that would fit a bank of rocker switches to control lights added to the Hummer.

> For 2003-2007 - a panel to replace the SXM module
> For 2008-2009 - a panel to fit the the opening under the HVAC controls

For the 2003-2007, a guy is selling a 3D printed compartment to replace the SXM module on Etsy... https://www.etsy.com/listing/9213136...ar-replacement

Would make it look much more integrated than slapping the standard rocker switches on the dash...

 

Hello, I would be very interested in the part from post #26. I just broke mine trying to remove visor. I would be willing to ship it for inspection as well after I go back into headliner to unplug and remove it.

 

@Jonesb930 Any chance you are still making parts??

 

Yes, I am still making the other clip, but have not tried to make the one you are looking for. I would need 1 good one, or a broken one with all the pieces to model it. I'm willing to give it a try, but the process may be slow. Where are you located?

Bill

 

I am in PA. Unfortunately I think all three upper tabs broke off but I still have them. I’m not in a rush as I never use the visor, but if you were able to make it that would be cool. I’m sure there are still other people who would purchase as well.