What is the least offset you can have before the wheel sticks out of the fender?

Would +25 stick out a lot?

 

OK, after more searching ....dumb question. BUT, I have seen Importkiller say +38 and 0 offset for stock H3 wheels. I just really confused.

 

never said that 0 is the stock backspacing......stock BS is 5.5 I believe....but backspace ain't as important here as offset soooooo to answer your question, stock is +38 anything less + will push the tire out towards and past the fender, more+ will pull the tire in towards the hub. So your +25 offset will stick out 13mm more than stock, or 0.511811024 inches.

 

Thanks for clearing that up, but I didnt say anything about backspacing either. Here is the post that confused me. https://www.hummerforums.com/m_17290/tm.htm

Thanks for the help though. Sticking out 1/2in wont be too bad

 

the zero I mentioned in that thread was what most aftermarket rims that fit the h3 back then were bieng sold as...not stock rims, sorry for the confusion. The rest of the post were typos...the + were meant to be -...my bad....hell that was an old thread