whats the hub bore of 2008 h3? 100mm , 106mm or 108mm?
Thread Starter
|
Junior Member
Joined: Jun 2009
Posts: 9
whats the hub bore of 2008 h3? 100mm , 106mm or 108mm?
im buying custom aftermarket wheels...the manufacturer needs the center hub bore...
i have been seacrhing around... some list it as 100mm...while another list it as 106mm.... while the tire and wheel buyer's guide magazine list it as 108mm
so which one is right?
i have been seacrhing around... some list it as 100mm...while another list it as 106mm.... while the tire and wheel buyer's guide magazine list it as 108mm
so which one is right?
Senior Member
Joined: Jan 2010
Posts: 101
Last edited by ShirtaDay.com; Feb 10, 2011 at 04:34 AM.
Banned
Joined: Aug 2009
Posts: 2,652
and the big hole in the wheel is,,,
100
it has a taper inside and a groove or ridge outside but the SMALLEST point read on my tape was between the 20 and 30 cm marks and not one mm could be seen beyond that
tom
oops, i mresured a wheel identical to my 07 h3 wheels,,,did they change 08?
it has a taper inside and a groove or ridge outside but the SMALLEST point read on my tape was between the 20 and 30 cm marks and not one mm could be seen beyond that
tom
oops, i mresured a wheel identical to my 07 h3 wheels,,,did they change 08?
Last edited by drtom; Jan 25, 2010 at 04:34 PM.
Thread
Thread Starter
Forum
Replies
Last Post
