Hydraulic Winch
#14
RE: Hydraulic Winch
I have a Milemarker Hydraulic 10,500 that I want to install on my H3. Did you take the supplied line from milemarker somewhere and have a manifold style fitting put on it? How did you manage to get it worked out? I didn't have any problems installing this myself on my Jeep but I'm not even sure I can get a tool to the steering rack fitting to start with in order to change it out. Any additional info or suggestions would be great.
#15
RE: Hydraulic Winch
Sorry so long responding. I bought a new power steering hose set online (about $65) brought it to
a hydraulic shop, they cut off the factory end on the pressure side and attached a new hose with the
same fitting that attachs to the mile marker hose. I also bought the hydraulic fitting set from Mile
Marker, I think it is the kit that is used for the jeep, it came with four adapters. The hose attachs
to the steering rack with a manifold type fitting I used a 10 mm socket with a swivel to loosen it from the
rack. There are also two hose clamps that bolt to the crossmember they are also 10 mm.
Jim
a hydraulic shop, they cut off the factory end on the pressure side and attached a new hose with the
same fitting that attachs to the mile marker hose. I also bought the hydraulic fitting set from Mile
Marker, I think it is the kit that is used for the jeep, it came with four adapters. The hose attachs
to the steering rack with a manifold type fitting I used a 10 mm socket with a swivel to loosen it from the
rack. There are also two hose clamps that bolt to the crossmember they are also 10 mm.
Jim
Thread
Thread Starter
Forum
Replies
Last Post
Mustanggirl666
PRIVATE For Sale / Trade Classifieds
1
11-26-2012 07:15 PM
Kimmea
PRIVATE For Sale / Trade Classifieds
0
08-29-2012 08:19 AM
parishh3guy
PRIVATE For Sale / Trade Classifieds
0
07-31-2007 05:39 AM
CruisinCarAudio
PRIVATE For Sale / Trade Classifieds
0
04-03-2006 03:07 AM