Had to replace pads in 06, H3, E-Brake shoe came loose while removing the brake drum.

QUESTION) How to put the E-Brake back on ?

There must be a technique in putting it back together with the 2 spring & button on the sides and also the top and bottom springs with the adjuster.
Spent a good amount of time on this...I would pull my hair out ..but I am bald already !

Attaching pictures.

Pic 1 shows after the shoes have dislodged.
Pic 2 - most important--shows the shoes and springs laid out on the floor .. as would be seen looking directly into the wheel. The other pics are general.
Any help would be immense !!
Thanks

 

Give You Tube a search. Lots of good info there.

 

Thanks...did look around You Tube first...but all are completely different than the H3.

 

Go around to the other side, the one you did not mess with yet, and LOOK at how it goes together. Service manuals are on line free.

 

Thanks Doc Olds, not sure if the last reply is going to show up; yes I have seen this drawing on the web and seems obviously easy & similar to the setup on other side as suggested. However the problem is what goes where first...more like a procedure, maybe the technical service bulletins would help. (I will also loosen up part "9" on the drawing above)
Meantime do you know the service bulletin site ?

 

Scroll down the attached link. I believe you'll find what you are looking for.
http://schwarttzy.com/wp-content/upl...king-Brake.pdf