I am putting a 3inch leveling kit (3"front torsion key, 2" rear shackle), with Tuff Country 4inch suspension lift. I am prepared to cut fenders a little and possibly add wheel spacers if needed for turning clearance.

However, i would just like to see this size of tires on an H3. Mainly the 15.5 width.

I know it will be slow and i may break some stuff, oh well, i wanna go big!

ANY PICS OF THIS SIZE OF TIRE ON AN H3??????????????????

 

I don't think you would have to cut anything. A couple of guys I go offroading just put wheel spacers, they got them off ebay, and that seemed to work, but these were not everyday drivers and the tires they put on them stuck pretty far out. I will see if I can get some pictures from them. Who cares if it goes slow it's a HUMMER not a Race Car.

Good Luck!!!!

 

I do not believe your two lift packages are entirely compatible?

Check your state laws, in many if your tires stick out beyond an inch from the fender, you will need fender flares. If that's the look you want, then have at it.

Waive to the turtles that blow by you drafting snails chasing sloths.

 

Thanks, now I gotta buy a new keyboard that's not covered in coffee spew.

 

^^^^^^^that's hilarious!!^^^^^^^^

 

stock up on lots of wheel bearings!!!

 

... and half shafts and front R&Ps and Steering gears and tie rods and intermediate shafts and front diff housings...etc.

 

if you could get a pic or two, that would be awesome! i might just go with the 37x15.5 r20 to stay on the safe side, hate to spend 3k on wheels and tires and not be happy cause they are too big, but would love to see pics to see for sure...