Remove Switch Panel, Driver Door, '06 H3
#1
Remove Switch Panel, Driver Door, '06 H3
Any tips / photos regarding the removal of the driver side door switch panel? Saw one thread describing the use of interior pry tools to do this. Hope to find a little more info / photos. My dealer even managed to break a hold down tab requiring the replacement of the switch panel. Would like to remove the panel without destroying anything! Harbor Freight has a low cost nylon trim & molding tool set that sounds like it might do the trick (5 Piece Auto Trim and Molding Tool Set)
Thanks Much.
Thanks Much.
#2
You should be able to do it with those. Or you could use a skinny, slot screwdriver. The switch panel is held in with a metal spring clip at front and back. Just pry up on alternating edges. I saw a writeup on speaker replacement that shows how to get them off while removing the door panels.
#3
Any tips / photos regarding the removal of the driver side door switch panel? Saw one thread describing the use of interior pry tools to do this. Hope to find a little more info / photos. My dealer even managed to break a hold down tab requiring the replacement of the switch panel. Would like to remove the panel without destroying anything! Harbor Freight has a low cost nylon trim & molding tool set that sounds like it might do the trick (5 Piece Auto Trim and Molding Tool Set)
Thanks Much.
Thanks Much.
The door switch panel controls comes out if you pry the ends only.
That is where the clips are located. Don't pry the middle section
I did not have to remove my whole door panel.
Last edited by wfturner; 12-23-2013 at 10:41 AM.
Thread
Thread Starter
Forum
Replies
Last Post
chrzanowski5
PRIVATE For Sale / Trade Classifieds
6
09-28-2012 09:01 PM
murderedc230
PRIVATE For Sale / Trade Classifieds
0
01-17-2010 10:21 PM
quadblaster240
PRIVATE For Sale / Trade Classifieds
6
08-28-2009 01:37 PM