H3 was backed into and they bent frame rails where d rings mount too. Can anyone tell me what there messurement is from inside of plate that d ring is on to iside of other d ring plate please

 

Sorry I'm confused. ..
Are you asking for horn measurements? As in spacing between them and position relative to ground?

 

If you look at your h3. The plate that has 2 holes on it that the d ring mounts to. What is the messurement front inside edge to inside edge

 

I'd like to see a pic or 2 of your H3 that was "backed into" and them "bent frame rails".... that would be interesting.

 

Jeez, this long and nobody will just give you the measurement? Here: Mine is 23 3/8" inside edge to inside edge.

 

Thank you 650


And doc. I was pulling someone out of a whole and after I pulled them.out of the hole. We came to a stop. Then they desiderate to mash on the gas and keep backing up. So from full throttle at 20ft the hit me while I was stopped. Deff won't be pulling random people out of the woods again

 

Ouch. Yeah, sometimes being a good samaritan hurts. When pulling someone out, never stop till THEY drag you to a stop!