Anyone have a Kent Moore J-44225 tool?
Thread Starter
|
Senior Member
Joined: Feb 2016
Posts: 121
Anyone have a Kent Moore J-44225 tool?
Hello,
As the title says, does anyone happen to own/have access to the Kent Moore J-44225 Balance Shaft Bearing Removal/Installation Tool for the 5-cylinder engines?
I'm not in a position to buy one right now (cheapest one on Ebay is $800 at the moment), but if anyone does have one laying around, would you be willing to do some type of Rental Agreement (Ex. I pay you $500 on Paypal/Venmo/Etc., I pay for shipping to/from, then owner refunds $400 at the end; something along those lines).
Working on an engine rebuild at the moment; can probably get away with using a universal Camshaft Bearing Tool, but the J-44225 would make life a lot easier.
Hope all is well with everyone!
As the title says, does anyone happen to own/have access to the Kent Moore J-44225 Balance Shaft Bearing Removal/Installation Tool for the 5-cylinder engines?
I'm not in a position to buy one right now (cheapest one on Ebay is $800 at the moment), but if anyone does have one laying around, would you be willing to do some type of Rental Agreement (Ex. I pay you $500 on Paypal/Venmo/Etc., I pay for shipping to/from, then owner refunds $400 at the end; something along those lines).
Working on an engine rebuild at the moment; can probably get away with using a universal Camshaft Bearing Tool, but the J-44225 would make life a lot easier.
Hope all is well with everyone!
Thread
Thread Starter
Forum
Replies
Last Post
ProphetPVD
PRIVATE For Sale / Trade Classifieds
20
Jan 19, 2015 03:09 PM
