Had the H3 serviced, later found out some tech cracked it.

Regardless, I ordered the base and looking to install it myself.

Does anyone know how to accomplish that?

Thanks.

 

2006 H3 - Rear Seat Cupholder




Component Name

1 Rear Seat Cup Holder Screw (Qty: 2)

Notice: Refer to Fastener Notice.
Tip: Fold the rear seat cushion forward to gain access to the screws.

Tighten 2 N-m (18 lb in)

2 Rear Seat Cup Holder

3 Rear Seat Cup Holder Retaining Clip

 

Not trying to hijack but anyone know the part number for #3?

 

Not a hijack, right on topic.

RETAINER. Seat Cushion
Part Number: 15255355 #17 below

 

Wish I checked this before I did it earlier!

So, I did figure it out.

I had just ordered the cupholder housing (#17).

Lifted the backseat and saw 2 screws. Removed the 2 screws and it popped out.

What I didn't notice, after I installed the housing is that it didn't come with the screws that hold the cupholder (those would be #16 per Doc's post).

So, took the ones from the old one, was kind of bitch lining it up, but the cupholder is in the housing.

I'm kinda pissed that I had asked my mechanic what it would cost to do, and he quoted me $75. I realize that it is cheaper to do yourself, but with the money I spend there, for 2 screws $75..

Anyway. Good on this. Thanks for the input guys!