Where is the best / easiest place to run a wire for auxiliary lights - from the engine bay through the bulkhead and into the cabin? Thanks in advance.

 

Best place would be found by a SEARCH: Hummer Forums - Enthusiast Forum for Hummer Owners - Search Results

 

Thanks for your lofty wisdom, I tried searching using various terms to no avail.

 

Under the dash behind the steering column is a factory pass-through for the wiring harness from the engine compartment. The H3 has a double firewall so there are also two grommets there. You could also drill your own hole and install a grommet where ever you wanted. I think that there are one or two other pass-throughs as well.

 

look where the clutch pedal would be and find a hole in one layer of the two layers. its a good place to drill a 3/4- 1 inch hole with a unibit or hole punch as i did. run wire thru a grommet or rubber hose and fill voids with putty.
youll be ready for the NEXT wires!