Anyone know anything about the SMA H3, I'm guessing one they put together for SEMA 05? It has a winch fairlead and cabe coming through the front bumer, implying they actually installed a winch behind the bumper. I'd like to find out more information about it it possible. Otherwise, I'll just take my bumper off and start taking measurements to see what and if this is possible.

 

[IMG][/IMG] like this one. Iheard SMA went out of bussiness
[IMG]local://upfiles/111/1C53B4D0787F4930AFE8E438DA0E8B12.jpg[/IMG]

 

Thats the thumb nail I've seen. I was hope to learn more about the mount and not have to reinvent the wheel.

 

next best bet buy a brush bar with a mount on it. I could not find that one anywhere and they are closed i tried calling them.

 

Or call this place ask for john he might be able to come up with something
http://www.stallioncustoms.com/

 

Nope. The brush guards I've seen with a winch mount stick the winch too low and out there waiting to be beat up.

A little perusing of my website www.etoracing.com would show you I am all about building rather then paying for what I need when it makes sense, and this one does, as I have the skill and the tools for this project. No need to pay ridiculous amounts of money for someone elses labor.

When I'm ready I'll spend the time with the front "bumper" removed and figure out how to build a nice mount
for a winch behind it, tied properly into the frame rails.

 

i know ramsey had a winch bumper set up for production but they couldnt get the initial 25 orders to put it into production, I ordered one and received a refund, the cost was $1400