Hello to all from New York
Thread Starter
|
Senior Member
Joined: Nov 2015
Posts: 101
From: Suffolk County, New York
Hello to all from New York
Finally took the time to register after lurking in this and other Forums for the past few months.
I'am the proud owner of an 06 H3 Slate blue with 107 K miles.
After doing numerous searches here, I leveled the front by turning the torsion bars up to 1/4 " below the maximum safe height. I then purchased used stock rims and mounted a set of 35" Duratracks on them, including the spare. I have changed all the plugs, cleaned the MAF and Throttle body with the proper cleaners. I have replaced all the fluids( front & rear differentials, transfer case and transmission filter & fluid and oil). I have changed all the rotors and pads.
Future plans include changing the old tired shocks and bumper stops, replacing the windshield pillar mouldings and possibly waking up the motor a little bit with a tune and small mods. Truck is running fine but under powered, specially with the 35's.
I thank Doc Olds and other members here for posting their experiences and knowledge. These members facilitated all my projects so far.
I apologize, for posting this in "reply" to another thread instead of starting a new thread but I'am unable to delete that post.
I'am the proud owner of an 06 H3 Slate blue with 107 K miles.
After doing numerous searches here, I leveled the front by turning the torsion bars up to 1/4 " below the maximum safe height. I then purchased used stock rims and mounted a set of 35" Duratracks on them, including the spare. I have changed all the plugs, cleaned the MAF and Throttle body with the proper cleaners. I have replaced all the fluids( front & rear differentials, transfer case and transmission filter & fluid and oil). I have changed all the rotors and pads.
Future plans include changing the old tired shocks and bumper stops, replacing the windshield pillar mouldings and possibly waking up the motor a little bit with a tune and small mods. Truck is running fine but under powered, specially with the 35's.
I thank Doc Olds and other members here for posting their experiences and knowledge. These members facilitated all my projects so far.
I apologize, for posting this in "reply" to another thread instead of starting a new thread but I'am unable to delete that post.
Thread
Thread Starter
Forum
Replies
Last Post
DAGKANA
PRIVATE For Sale / Trade Classifieds
0
Oct 19, 2010 08:14 PM
tarheel_34
PRIVATE For Sale / Trade Classifieds
26
Feb 4, 2007 11:40 PM