Hi.

I'm selling the nerf bars of my 07 H3. Will these fit the H3 Truck? I have someone driving in to look at them tomorrow. Don't want to waste their time if the fitment is different.

 

They will bolt on but they will be too short.
The H3T has a longer wheelbase.

 

From the back doors up,the're the same, i read here.
Should be fine.

 

Well you read wrong.
From the FRONT doors forward they are the same.
The rear doors are different and the rear axle is further back.

H3 nerfs WILL BE too short for an H3T !

 

X2! From the Rear of the front door forward they are the same Body Shell wise. The Frame, now that is an entirely different story. They will bolt up to some existing holes but they will be pretty useless for the rear passengers.


Not sure where the other guy "read it here".

 

I placed pictures of a 3 and a t one above the other,drew lines from doors .
The t back door drops straight down but looks like the same width,maybe a bit less than the 3 rear door.
It might be good if someone could measure the width of both doors on both vehicles since it sounds like the nerfs will bolt on.

 

The nerfs will bolt on, but on the H3 they end approx. 1/2 way on the rear door because the rear tire is closer than on the H3T.
The wheelbase of the H3 is 112". The wheelbase of the H3T is 134".
They will end 1/2 way on the rear door of the H3T so there will be a gap of about 12" or more before the end of the door.
Since the end is also a large radius they won't be very useful for getting into the rear seat.

 

They will fall short...