GM Fuel Door Kit
Thread Starter
Joined: Jan 2007
Posts: 120
From:
GM Fuel Door Kit
Just bought the GM fuel door kit and installed it... but for some reason I can't get it to sit flush on the fender (it leaves about a quarter inch gap). Is there supposed to be a rubber seal that goes around it? If so mines doesn't have one...
Joined: Jan 2007
Posts: 233
From: Alberta, Canada
RE: GM Fuel Door Kit
Hey Tarheel
Try this link that I found in these forums... may help ya if you missed something during your installation!!
http://www.rausite.com/hummerh3.htm
Good Luck
Try this link that I found in these forums... may help ya if you missed something during your installation!!
http://www.rausite.com/hummerh3.htm
Good Luck
Joined: Sep 2005
Posts: 4,300
From:
RE: GM Fuel Door Kit
The best thing to do is to remove about 4 of the plastic tabs on the wheel well get your hand up in there.
Let someone hold a towel double up and hold it on the cover and with you hand inside the wheel well with your hand feel the metal pins then take a rubber hammer tap them outside where the towel is go around to all the tabs it will fit flush.
Then put the plastic tabs back on the wheel well cover then your done.
Joined: Sep 2005
Posts: 4,300
From:
RE: GM Fuel Door Kit
ORIGINAL: tarheel_34
Just bought the GM fuel door kit and installed it... but for some reason I can't get it to sit flush on the fender (it leaves about a quarter inch gap). Is there supposed to be a rubber seal that goes around it? If so mines doesn't have one...
Just bought the GM fuel door kit and installed it... but for some reason I can't get it to sit flush on the fender (it leaves about a quarter inch gap). Is there supposed to be a rubber seal that goes around it? If so mines doesn't have one...
Thread
Thread Starter
Forum
Replies
Last Post
Davidh3
PRIVATE For Sale / Trade Classifieds
0
Nov 10, 2011 04:51 PM
geeggee
PRIVATE For Sale / Trade Classifieds
2
Feb 28, 2008 03:59 PM
GarrettMoore
PRIVATE For Sale / Trade Classifieds
0
May 5, 2007 11:29 AM
