ok I have a hummer H2 now my encoder motor went out and I got a new one and I did but the transfer case in neutral and I tried to but it on but would not go on so then I tried to but it in 4wdhi did not go then but it in 4wd low and it did go on but now it will not come out of 4wd low and I thought it was to be in neutral so did I get a bad encoder motor or what can some one help me

 

no instructions?. procedure?
it sounds like you are guessing?
im sure there is ONE way to do it right. needs to be in the proper position to start.

the book? or ?

 

Posted this in the New Member area too, in the very thread that told you that section is NOT for technical questions.

Check this out.... if you have an H2 QUESTION, .... you POST IT IN THE H2 SECTION.

Also please avoid duplicate posts at all times.