Are these lights plug & play? Is there a factory pigtail or wire harness thats already in that area to just plug these lights into?

Also, in regards to the switch...I noticed in my H3 that there are 2 small circular plastic peices on the dash, under the stero and AC controls....is this where a switch would be factory installed? What's behind it?

I'm interested in purchasing some auxillary lights, not necessarily these, and would love if the wire harness' were already there and I could just tap into them.

So, again, is there a wire harness in that area already and are those 2 plastic holes on those dash for switches?

Please advise.

 

I'm not sure about the harness, but I know a few people have used those open spots under the radio for auxiliary switches. I bought an oval switch to fit in there to use for my KC slimlights that I bought for my brushguard. I got them online but found them at pep boys after that. The black center piece pops out then you just have to run the wires from there. I don't have better instructions since I haven't done it yet. I'm sure you can search a little and find some posts on this. Good luck!

Ben

 

Only a small amount of the harness is there....the relay, switch and most of the underhood harness comes with the kit.