Blower motor help
#1
Blower motor help
I know I know - we all have the blower motor issues but heres where I'm at:
Bought this 2006 h3 used
A/c cut out 2 weeks later
Pulled the resistor - it was toasted
Pulled the harness - someone had tried to repair it previously and did a crap job
Replaced harness, resistor, and relay.
Blower blows now but air compressor does not kick in
Also, at the switch, 1 blows low, 2 cuts off, 3 & 4 blast warm air.
Checked the switch - no burn marks, I'd check the ohms but I don't know what values it should have.
Any pointers?
Bought this 2006 h3 used
A/c cut out 2 weeks later
Pulled the resistor - it was toasted
Pulled the harness - someone had tried to repair it previously and did a crap job
Replaced harness, resistor, and relay.
Blower blows now but air compressor does not kick in
Also, at the switch, 1 blows low, 2 cuts off, 3 & 4 blast warm air.
Checked the switch - no burn marks, I'd check the ohms but I don't know what values it should have.
Any pointers?
#5
1st picture is what it's supposed to look like.
Second picture is after I put a blob of solder on it trying to see if it'd at least make a connection to blow air out of my dash vents instead of my defroster. You can't see the burned connection cause I covered it with solder and I'm away from my shop at the moment so I can't pull the solder off.
Second picture is after I put a blob of solder on it trying to see if it'd at least make a connection to blow air out of my dash vents instead of my defroster. You can't see the burned connection cause I covered it with solder and I'm away from my shop at the moment so I can't pull the solder off.
Thread
Thread Starter
Forum
Replies
Last Post
08grayH3
PRIVATE For Sale / Trade Classifieds
0
06-11-2012 07:58 PM
teamtitleist
PRIVATE For Sale / Trade Classifieds
3
09-15-2010 11:52 PM