No compression on cylinder #3

Closed Thread Subscribe

Thread Tools

Search this Thread

Jul 28, 2022 | 12:19 PM

#21

Hummer6895

Junior Member

Joined: Jul 2022

Posts: 13

Quote:

Originally Posted by register1987

Ok I used a left handed drill bit and it pulled the broke bolt right out. I had the head rebuilt at a local shop for $240. I am getting ready to install the head tonight. While reading thru the install steps it says things like.

Tighten the cylinder head bolts in sequence to 22 ft. lbs. (30 Nm). Use the J 45059 to rotate the cylinder head bolts in sequence an additional 155 degrees.

Do I just turn the bolt 155 degrees after I reach the required torque.

would you say 600 for a remanufactured head with all new valves, springs, lifters/lashers, cams ect installed so it's just a fully built head pull and install worth it?

Jul 28, 2022 | 02:51 PM

#22

Doc Olds

Super Moderator

Joined: Jul 2007

Posts: 13,090

From: Boat Town USA MI

Quote:

Originally Posted by Hummer6895

would you say 600 for a remanufactured head with all new valves, springs, lifters/lashers, cams ect installed so it's just a fully built head pull and install worth it?

Who are you talking to in this SIX YEAR OLD THREAD? Register 1987's Last Activity: 08-20-2021 12:32 PM.

Not how it is done. Start a NEW THREAD, avoid digging up OLD Dawgs. READ: Old Threads/'Necro-Bumping'