Does anyone have a diagram for the factory Monsoon amp in the rear? I'm wiring up an aftermarket amp, and need to know the positive and negative wires for the sub input, and I also need a switched 12V power wire. Thanks!

 

i found this link that may or may not help you worth a try

http://www.ls1tech.com/forums/archiv....php/f-19.html

 

dont cut the green...............it will go ..........BOOM....LOL

 

azz7772, is there a particular thread you're referring to? Thanks!

 

Audio Amp C1
1-TN-Left Front Low Level Audio Signal (+)
2-D.GN-Left Front Low Level Audio Signal (-)
3-D.GN/WH-Left Rear Low Level Audio Signal (-)
4-BN-Left Rear Low Level Audio Signal (+)
5-OG-Radio Mute Signal
6-PK-Radio On Signal
7-Not Used
8-GY/BK-Remote Amp Sense Line Signal
9-OG/BK-Right Front Low Level Audio Signal (-) / D.BU in early models
10-L.GN-Right Front Low Level Audio Signal (+)
11-D.BU-Right Rear Low Level Audio Signal (+) / OG/BK in early models
12-BK-Right Rear Low Level Audio Signal (-)
13 to 16-Not Used


Audio Amp C2
1-BK-Left Front Tweeter Speaker Output (+)
2-YE-Left Front Tweeter Speaker Output (-)
3-L.GN-Right Front Tweeter Speaker Output (+)
4-PU-Right Front Tweeter Speaker Output (-)
5-YE-Left Rear Speaker Output (-)
6-BN-Left Rear Speaker Output (+)
7-L.BU-Right Rear Speaker Output (-)
8-D.BU-Left Rear Speaker Output (+)
9 to 12-Not Used
13-L.GN-Right Front Speaker Output (+)
14-D.GN-Right Front Speaker Output (-)
15-TN-Left Front Speaker Output (+)
16-GY-Left Front Speaker Output (-)


Audio Amp C3
1-OG-Battery Positive Voltage
2-BK/WH-Ground
3-D.BU/WH-Left Subwoofer Speaker Output (+)
4-L.GN/BK-Left Subwoofer Speaker Output (-)
5 to 6-Not Used
7-L.BU/BK-Right Subwoofer Speaker Output (-)
8-L.BU/BK-Right Subwoofer Speaker Output (+)


On the radio should be a 24-pin connector (2-rows (A and B) of 12)
B1-OG-Battery Positive Voltage [I believe this is constant and not switched]
B3-PK-Radio On Signal (not 12v)
B6-OG-Radio Mute Signal (not 12v)

 

Thanks mountainbiker! I really appreciate it!

 

Are there there 3 seperate amps, or just 3 different plugs?

 

Most likely you have C1 going from your head unit to the amp and C2 leaving your amp out to the speakers.

 

don't use the factory power and ground wires for a new amp!!!!! They are too small of a gauge wire and will limit your new amp.

 

importkiller, I'm not. I just need to wire up an LOC to the Monsoon amp signal wires. Does anyone know an easy remote turn on wire I can tap? Thanks.