Control arms or ball joints
#1
Control arms or ball joints
I got a sort of front end noises . When stop . Turn . Accelerate. You name it
The shop told me the tie rod and ball joints are shot
I replaced the tie rod only .
Will now do the ball joint but I'm debating if should replace the control arms too as the BJ comes installed already .. looking at moog . What brand are suggested
If so should both upper and lower be replaced . I don't off-road
Is this a DYI job
I'm also planning to change the CV shafts . What's a good brand
The shop told me the tie rod and ball joints are shot
I replaced the tie rod only .
Will now do the ball joint but I'm debating if should replace the control arms too as the BJ comes installed already .. looking at moog . What brand are suggested
If so should both upper and lower be replaced . I don't off-road
Is this a DYI job
I'm also planning to change the CV shafts . What's a good brand
Last edited by H2Miami; 03-17-2017 at 07:02 PM.
#3
Unless the CV boots are torn they should be good. I'm debating this exact same thing. I replaced my tie rods (which were shot) with the Xtreme Duty ones from Dmax store but my bushings in my controls arms are a little cracked.
I can't decide to replace the bushings or just the entire control arm. I found new control arms from Detroit Axle for $60. I'd rather go all polyurethane and not worry about the damn things drying out and cracking though.
I can't decide to replace the bushings or just the entire control arm. I found new control arms from Detroit Axle for $60. I'd rather go all polyurethane and not worry about the damn things drying out and cracking though.
#4
The boots are in good shape but I'm hearing a click.when turn . Not sure if it s coming from the axle or the ball joints .
Because I think once the axle are replaced new alignment is needed I rather to do all at once . Same with the arms
Is Detroit a good brand or you pick random
Tux
Because I think once the axle are replaced new alignment is needed I rather to do all at once . Same with the arms
Is Detroit a good brand or you pick random
Tux
#6
Calif ... I replaced the BJ in my Honda and was very fun job .. Around 5 hr trying to figure out how to use the press . Very scare when the BJ pops . Sound like a bomb
Lol
That's why I was thinking in change the Control arms to moog which comes with the BJ installed
Lol
That's why I was thinking in change the Control arms to moog which comes with the BJ installed
#7
Hey Miami,
Not sure about the brand, I started with "Pro-forged" so I am staying with that as I continue replacing parts. For me, it's time consuming, so I went with the shop for this.
One thing that really helped me was replacing every bushing I could find. I have an 06 and they were beat. Next will be the anti sway bars front and back.
Not sure about the brand, I started with "Pro-forged" so I am staying with that as I continue replacing parts. For me, it's time consuming, so I went with the shop for this.
One thing that really helped me was replacing every bushing I could find. I have an 06 and they were beat. Next will be the anti sway bars front and back.
Thread
Thread Starter
Forum
Replies
Last Post
skicranmore
PRIVATE For Sale / Trade Classifieds
4
09-24-2014 08:36 AM
Diesel
PRIVATE For Sale / Trade Classifieds
2
02-25-2009 01:08 AM