On my new PIAA's, it came with a digital switch with 2 buttons that goes to a relay for each lamp..one button for on/off and one button for spot/flood.
I would like to consolidate this digital switch to a single analog switch that works in a on/off/on mode.

I have a switch designed to do this..

---12v+ input
---12v+output
---12v+ input

Anybody know if it will work like this??...

---12v+ output 1
---12v+ input
---12v+ output 2

 

it should work that way, center pole is making no contaact when in center so you are fine there, will make contact with pole 1 when in the up position and contact with pole 2 when in the down position,but instead of getting power from pole 1 or 2 and sending it to the center pole it will be getting power from center and sending it to pole 1 and 2 (up&down)

yea should work ok.