Hummer Forums - Enthusiast Forum for Hummer Owners

Hummer Forums - Enthusiast Forum for Hummer Owners (https://www.hummerforums.com/forum/)
-   PRIVATE For Sale / Trade Classifieds (https://www.hummerforums.com/forum/private-sale-trade-classifieds-10/)
-   -   Can anyone tell me what goes here??? See picture. (https://www.hummerforums.com/forum/private-sale-trade-classifieds-10/can-anyone-tell-me-what-goes-here-see-picture-27427/)

Evo-Z 04-01-2012 08:20 PM

Can anyone tell me what goes here??? See picture.
 
Hi, guys.
I own a 05 H2, recently get new set of interior trim piece, but on the drive side piece that comes with a hole which my hummer do not have. search around web saw some picture that is something there, so can anyone tell me what is that? a switch or sensor??
Thanx a lot.
https://farm8.staticflickr.com/7184/...2b243830_z.jpg

bflorin 04-01-2012 08:54 PM

heated washer switch

dr.drew2 04-02-2012 06:52 PM

heated washer switch
 
:Dgo to radioshack you can get a square push in electricaL SWITCH. 3.00 FIX. THE GMSWITCH IS NO LONGER AVAILABLE.. i did it to mine and it looks great..

LoJac963 04-02-2012 09:19 PM

Where did you pick up the argentanium dash pieces from??

Evo-Z 04-03-2012 08:19 AM

thanx for the input guys.
I got my carbon fiber looking trim off ebay. GM oem parts, quality really good.
BTW, for dr.drew2: did u have hard time to install the rear piece (for rear seats AC vent and radio control). there is a plastic pocket under rear climate control which not screwed but melted in. how did u fix this problem??

dr.drew2 04-03-2012 01:38 PM

can you heat up where the plastic joint is.. you should be able to sperate it there.
then reattach using two part epoxy.

LoJac963 04-03-2012 06:42 PM

^correct I read in another thread you have to melt those points then glue in the pocket to the new trim piece

I've seen that kit on ebay for an eternity now but the sellers comment of the pieces being scratched has always deterred me.

Were your pieces scratched at all?

dr.drew2 04-03-2012 07:00 PM

dash kits
 
I had one piece that was scratched very slightly. but it was not bad enough to upset me. I put the carbon fiber dash kit in. The hardest part about the whole thing was pushing the little white buttons in the release the steel rods that retain the passenger grab rail working around the passenger dash airbag;)

Evo-Z 04-04-2012 10:05 AM

Mine only have one tiny scratch on the middle piece near the right side air vent.
everything looks great. and yes, the passenger side handle bar is tricky, but after take off the glove box and panel near the door jam, it's not that hard.

bflorin 04-04-2012 07:17 PM

They must be getting down to the last of that stock. All my carbon fiber panels came loaded w/ all buttons, vents, 12volt, plastic pocket on rear of center console.


All times are GMT -5. The time now is 10:36 AM.


© 2024 MH Sub I, LLC dba Internet Brands