Ed's06h3 hummer build
I figured i might as well start a build thread. I have an 06 H3 (base) black. I got it from a nissan dealer 3 years ago..
She was chromed out in the beginning: chrome side mirrors, grille, door handles, etc.....
This is how she looks today:

My first mod i got rid off the Bridgestone duelers and picked up a set of Goodyear Duratracs..

I wanted a little bit more power so i picked up a Air-Doc intake:

GM performance (touring) dual exhaust with chrome tips:


Navigation system:

Replaced the chrome fuel door with the Defender Worx (black) fuel door

Then i replaced the oem tail-lights with the LED tail-lights and a pair of light guards

Finally got rid off the chrome grille and was lucky enough to pick up a black grille off craiglist!
She was chromed out in the beginning: chrome side mirrors, grille, door handles, etc.....
This is how she looks today:

My first mod i got rid off the Bridgestone duelers and picked up a set of Goodyear Duratracs..

I wanted a little bit more power so i picked up a Air-Doc intake:

GM performance (touring) dual exhaust with chrome tips:


Navigation system:

Replaced the chrome fuel door with the Defender Worx (black) fuel door

Then i replaced the oem tail-lights with the LED tail-lights and a pair of light guards

Finally got rid off the chrome grille and was lucky enough to pick up a black grille off craiglist!
I removed all the chrome, the previous owner installed chrome covers (side mirrors, door handles, and antenna base cover). I plastidip the chrome hood handles & center caps (will do entire wheels in the future)



Daystar panel and Lev O gage



Daystar panel and Lev O gage
You have been busy, like a one man economic recovery unit!
KUDOS!
Everything you have done has been good stuff, but I really like the light switches, where and how you mounted them.
KUDOS!Everything you have done has been good stuff, but I really like the light switches, where and how you mounted them.
Last edited by Doc Olds; Oct 8, 2012 at 01:54 PM.
Thanks........it was a easy install (switches) you just have to remove the center console (there is a screw behind the shift **** you will need a Allen key to remove it)...when you remove it the console just pops off...then you just measure & cut from there...I know some newer model hummers have the coin hole




















