|
dscaberboy -> RE: TRANS FLUID LEAKING FROM FRONT WHEEL (11/23/2007 2:34:41 PM)
|
I think it was just a trans cooler line leaking near the clamp. It hadn't leaked any more, but I did see some fluid on top of the A arm. I tightened the clamp a bit, and am waiting to see if the issue goes away completely. BTW, I am halfway through the conversion to run on SVO. The next step is dropping the rear tank and modifying it with the heat exchanger and HOTFOX. I'll take any advise on this one that is offered: I am using a goldenfuelsystems conversion. I paln to use the stock fuel tank switch (dash), and a Pollack 6-way valve under the hood. Is there an easy way to cripple (eliminate) the stock tank swithcing valve (on the pass side framerail). It just seems like a pain to get to. I was wondering, if I just unplugged it's harness while it is in the front tank mode, if that will stay in front mode, and would that effect anything else on that circuit? Problem is that I don't want to use the stock valve for SVO, only diesel. I';m running triple bypass line to the rear tank to pick up the SVO. I was also considering just disconnecting the stock rear fuel lines and capping them. Since I will be using a seperated, isolated lift pump for SVO, I figured thhat the valve could just switch to the rear tank, but have no actual fuel sorce on the tank end of the lines. I also plan to isolate the stock lift pump so that is stops when the rear tank is actuated, and the aux pump is turned on , and vice versa. Thanks in advance Doug
|
|
|
|