Hummer Forums   Hummer Classifieds   Photo Gallery   Member List   Calendars   Search   Forum FAQ   Contact HF   Sponsors
  Hummer Lineup   Hummer News   Hummer Recalls   TSBs   Timeslips   Register   Login

Under body armor-install issues   Printable Version Hummer Forums >> Hummer Lineup >> Hummer H3 >> Under body armor-install issues Page: [1] Login Message << Older Topic   Newer Topic >> Under body armor-install issues - 8/24/2007 3:21:08 PM    alrock Posts: 1058 Joined: 5/12/2007 From: Scottsdale, AZ Status: offline I just picked up the under body armor, usually called UCP here by myself and others, and I could not get it installed last night. Simply put, I cannot get the bolts to line up. For the rear armor I could not get the front center bolt to line up straight and not cross-thread into the frame until I reversed the installation directions--and it was still a b*tch. For the front plate, I installed one rear bolt (through the rear armor as per the instructions) and then could not get the front bolts to line up to the holes where the front skid plates end (in the front crossmember). The front bolts were off at least 1/8 of an inch and simply werent' going to go in. I've heard of success stories putting these in. Has anyone had my problems and can help me get these on? Am I missing something here? I would add that the rear armor seemed about 1mm too small and the front armor was 1mm-2mm too large. Maybe if I relocated the middle crossmember 1mm it would be perfect--yeah, right. Not too mention that at 7 pm it was still 105 out, I had just shut off the truck and it was firiggin' hot underneath. _____________________________ Post #: 1 RE: Under body armor-install issues - 8/24/2007 5:29:16 PM    Doc Olds Posts: 3807 Joined: 7/11/2007 From: Boat Town USA (Michigan 48045) Status: offline Those UCPs need tweeking, so I've been told?  Have not done one myself?  Air tools; a die grinder, and a drill would set you up. I have been looking at the set up. (in reply to alrock) Post #: 2 RE: Under body armor-install issues - 8/24/2007 11:25:33 PM    alrock Posts: 1058 Joined: 5/12/2007 From: Scottsdale, AZ Status: offline quote: ORIGINAL: Doc Olds Those UCPs need tweeking, so I've been told?  Have not done one myself?  Air tools; a die grinder, and a drill would set you up. I have been looking at the set up. Doc, if I just had a garage and those tools I'd be all over it! Living in a condo with a carport I'm a bit hamstrung. I have to do my work in a buddy's driveway. Do you think a standard drill will help me increase the hole sizes? _____________________________ (in reply to Doc Olds) Post #: 3 RE: Under body armor-install issues - 8/25/2007 6:18:50 AM    jdrew Posts: 1352 Joined: 11/6/2006 Status: offline Mine was a tight fit, but i was able to get it on... was a bit frustrating... _____________________________ 05 H2 SUT Slate Blue LUX w/NAV 07 Dodge Charger R/T w/Hemi Hate Cops? Next time you are in trouble, call a crackhead... (in reply to alrock) Post #: 4 RE: Under body armor-install issues - 8/25/2007 6:41:53 AM    Doc Olds Posts: 3807 Joined: 7/11/2007 From: Boat Town USA (Michigan 48045) Status: offline I called my bud who has put the underbody pkg on his.  Yes a drill and a set of bits would help get the holes in line.  He said he and a friend did it together and tried to get all the bolts started just a bit before tightening anything.  Clearly, it is a PITA to install.  Good luck. (in reply to jdrew) Post #: 5 RE: Under body armor-install issues - 8/25/2007 9:03:23 AM    H3X442 Posts: 199 Joined: 11/8/2006 Status: offline If these are the GM underbody protection I had no trouble installing mine. They fit just as the instuctions stated exactly. Steve _____________________________ 2009 H3 championship Edition luxury pkg,off road,,sunroof,trailer pkg.Dark Gray roof rack,rocker rail protection,xm radio,Nav and roof rail air bag (in reply to Doc Olds) Post #: 6 Login OR Register now to post a reply to this forum topic. Page:   [1]   Hummer Forums >> Hummer Lineup >> Hummer H3 Jump to: Select a ForumAll Forums---------------------- [Hummer Forums - General] - - New Member Area - - Off Topic - - - - Sports Discussions - - Sights N Sounds - - General Hummer Talk - - Ride of the Month - - Meets, Events, and Shows [Hummer Lineup] - - Hummer H1 - - Hummer H2 - - Hummer H2 SUT - - Hummer H3 - - - - H3 Frequently Asked Questions - - - - - - Head and Valve Problems. - - Hummer H3T - - Hummer Concepts [Brand Reviews] - - Audio Visual/Interior Modifications - - Detailing - - Drivetrain Area - - - - Intake, Headers and Exhaust - - - - Nitrous, Super Chargers, & Turbos - - - - PCM & Fuel Systems - - - - Suspension - - Tire and Wheel [Sponsoring Vendors & Classifieds] - - Sewell Hummer Parts - - Member Group And Special Buys - - PRIVATE For Sale / Trade Classifieds - - Private 'Wanted' Classifieds [Other] - - Hummer Forums Help & Suggestion Center

Today's Posts Most Active Topics Make A Donation Forum Rules & FAQ RSS Feeds Hummer Prices Hummers Hummer H1 Hummer H2 Hummer H3 Featured Sponsors Advertising Info Top 10 Posters hummbob 16160 3hummers 11820 muddydawg75 9960 importkiller 7254 blackstangs2 6826 hummerguy 6684 trey124 4626 rhill20 4549 doc olds 3807 h34 pleasure 3735 New Vendors Hummer Parts Club Sewell Parts Online AMSOIL - Performance Oil Technology G-Style Hummer Accessories

Contact Us | Advertising | Automotive Directory | About Us | Link To Us | Archive | Hummer Links | Legal | Privacy Policy | © Hummer Forums.com