|
Linus Gump -> RE: Rear Caliper Rebuild (7/5/2007 9:28:42 PM)
|
Grab your phone book and start calling brake places. Odds are, there is a local company where you live that will do that type of work. Just about anybody who specializes in hydraulics will know who does cylinder rebuilding, if they don't do it themselves. In my area, I can think of several places just off the top of my head who would do that type of work. Or, if you are mechanically inclined to take them out of your vehicle, odds are, you are mechanically inclined enough to rebuild them. All that is needed is the rebuild kit, a hone, a drill (preferably a drill press with vise), and a steel brush and brake clean to remove crud. Micrometers are also good to have to ensure the bore is round and not too big after you hone it out.
|
|
|
|