K&N Intake Install Help Needed

Hummer Forums Hummer Classifieds Photo Gallery Member List Calendars Search Forum FAQ Contact HF Sponsors
Hummer Lineup Hummer News Hummer Recalls TSBs Timeslips Register Login

K&N Intake Install Help Needed

Printable Version

Hummer Forum >> Brand Reviews >> Drivetrain Area >> Intake, Headers and Exhaust >> K&N Intake Install Help Needed

Page: [1]

Message

<< Older Topic Newer Topic >>

K&N Intake Install Help Needed - 5/13/2007 4:05:44 PM

ejdelong

Posts: 6
Joined: 5/6/2007
Status: offline

Getting ready to install a K&N 57 Series air intake filter on 06 H3, any advice and is it something that is pretty straight forward. Any tips or advice would be helpful.

thanks to all for this great forum

Post #: 1

RE: K&N Intake Install Help Needed - 5/14/2007 11:59:22 AM

littlehummerboy

Posts: 2176
Status: offline

quote:

ORIGINAL: ejdelong

Getting ready to install a K&N 57 Series air intake filter on 06 H3, any advice and is it something that is pretty straight forward. Any tips or advice would be helpful.

thanks to all for this great forum

Use the search function on the forum, several members here have installed it, and they all said it was very easy!

(in reply to ejdelong)

Post #: 2

RE: K&N Intake Install Help Needed - 6/21/2007 7:41:49 PM

Desert H3

Posts: 17
Joined: 4/30/2007
Status: offline

The install is very easy to do, it should take about 30 to 45 mins. First take off the older air box and can from above the engine all the way over to the intake. Second put the rubber lining around the metal intake box frame (tou know that pieace of metal that came in the box from K&N) Third the place the tubing and the two wire clamps on above the engine, it is the pictures. The put in the metal with the rubber lining and then put in the tube. Dont worry if it doesn't go perfectly into the curcle... the air filter will reach. Make sure to screw the bracket to the engine tight, I lost my screw for that bracket the first day. (The bracket is the one which goes from the middle of the tube down.) If you need I can help you more. It is easy to do, make sure you put the rubber

on the metal right. There are three pieces, the smallest go inside the whole, the longest goes over the top and side and the second shortest goes on the bottom.

Good Luck, Justin

_____________________________

Justin

(in reply to ejdelong)

Post #: 3