vibration/rattle

Hummer Forums Hummer Classifieds Photo Gallery Member List Calendars Search Forum FAQ Contact HF Sponsors
Hummer Lineup Hummer News Hummer Recalls TSBs Timeslips Register Login

vibration/rattle

Printable Version

Hummer >> Hummer Lineup >> Hummer H1 >> vibration/rattle

Page: [1]

Message

<< Older Topic Newer Topic >>

vibration/rattle - 5/17/2008 9:21:05 PM

2doorh1

Posts: 59
Joined: 5/14/2008
Status: offline

Well, here's another question that I have been chasing for the last 4 years since I have had the truck. When idling, it has a very annoying vibration/rattle. This is coming from somewhere in the exhaust, because if you add just a touch if throttle, it goes away.

As you all know, these things have more heat shields than the space shuttle, so they are always suspect but just when I think I have found the culprit, it starts again.

Anyone else had this?

My truck is a 97 H-1 2 door model with the 6.5 non turbo.

Post #: 1

RE: vibration/rattle - 5/17/2008 9:37:59 PM

3hummers

Posts: 11785
Joined: 9/23/2007
Status: offline

Not really but UCP, heat shields and muffler hangers are all prime suspects. Have you tried putting neoprene washers between the bolts and the above potential offending items?

_____________________________

2006 H1 Alpha wagon
2000 H1 Slantback
1997 H1 wagon
2008 H3 Alpha

(in reply to 2doorh1)

Post #: 2

RE: vibration/rattle - 5/20/2008 12:48:36 PM

hummech

Posts: 50
Joined: 4/29/2008
Status: offline

i would say one of the welds on the exhaust crossover pipe cracked,(that is the pipe that is under the center of the vehicle and crosses over right in front of the trans pan) or it is a broken right exhaust manifold heat shield. those are the two common ones.

(in reply to 3hummers)

Post #: 3

RE: vibration/rattle - 5/20/2008 1:25:40 PM

2doorh1

Posts: 59
Joined: 5/14/2008
Status: offline

Thanks.

This will probably be your laugh for the day, but is there any good way to look at or get to those two items to diagnose or fix? For such a large hunk of truck, they seem to be the most cramped where it matters, especially with the underbody cage.

Any advice on this would be appreciated. Thanks.

(in reply to hummech)

Post #: 4

RE: vibration/rattle - 5/20/2008 1:35:32 PM

3hummers

Posts: 11785
Joined: 9/23/2007
Status: offline

2door, now that I think about it I did have an annoying vibration on the 97 that turned out to be the UCP was slightly bent up to where it made very slight contact with the exhaust system. You might look at that also.

_____________________________

2006 H1 Alpha wagon
2000 H1 Slantback
1997 H1 wagon
2008 H3 Alpha

(in reply to 2doorh1)

Post #: 5

RE: vibration/rattle - 5/20/2008 3:05:25 PM

hummech

Posts: 50
Joined: 4/29/2008
Status: offline

you can start the engine, keep it in park and get under the hummer in the front engine area and listen for the rattle. both can be reached from under the hummer.
3 hummers is also correct that a bent up drive line protection intermediate section making contact with the exhaust crossover pipe will also cause a rattle.

(in reply to 3hummers)

Post #: 6

RE: vibration/rattle - 6/4/2008 4:40:26 PM

hmcoleap

Posts: 223
Joined: 6/30/2006
Status: offline

My money is on a cracked heat shield - the good news is that rattles at idle are easy to find. \\; Turn thr truck on, chock the wheels so they won''t go anywhere under any circumstances, get under it, and use a long pry bar or screwdriver to poke the areas where you hear the rattle. \\; When you touch the right spot and the rattle stops, you will know what part is the culprit. \\;
\\;
Good luck...

_____________________________

- -Manny

/''T''|[___|___]
[---T--L -OlllllllO-]
()_)"""()_)/"**"\)_)
http://www.serious4x4.com

(in reply to 2doorh1)

Post #: 7