H3 - How To: Remove Mirror Caps w/Pics

  Printable Version
Hummer >> Hummer Lineup >> Hummer H3 >> H3 Frequently Asked Questions >> H3 - How To: Remove Mirror Caps w/Pics Page: [1]
Login
Message << Older Topic   Newer Topic >>
H3 - How To: Remove Mirror Caps w/Pics - 1/5/2008 1:50:18 PM   
EarthQuakeAV


Posts: 6
Score: 0
Joined: 12/17/2007
Status: offline
This project started because another member wanted to exchange his chrome mirror caps for my black ones.  I could only find some information about taking off the mirrors from the Muth (signal mirrors) website.  I used some of their instructions to shortcut the process a bit so you just remove the mirror caps rather than the entire mirror housing and door panel. 

To do this all you need is a T-15 (and maybe a t-10) torx screwdriver and either a flathead scredriver (a pretty large one) or an automotive trim removal too (something good to pry with).

Start by rotating the entire mirror housing and arm, forward...just push on it toward the front of the vehicle.  Next, push the bottom of the mirror all the way in, allowing the top of the mirror to stick outside of the mirror caps.


At the base of the mirror insert your prying device (flathead screwdriver), right about the center of the mirror base.  In the center is a solid piece that you can use to pry without cracking the mirror or the mirror cap. When you have inserted your prying device, carefully and slowly push up (rather than down) to slide the mirror itself upward.  The mirror will pop free after moving it upward about 1/2 to 3/4 of an inch.  CAUTION - BE CAREFUL NOT TO CRACK THE MIRROR OR THE PLASTIC BORDER AROUND THE MIRROR


This is the inside of the housing without the mirror:


The next step is to remove the mirror positioner.  Using the T-15 torx screwdriver loosen the 4 screws holding the mirror positioner in place.  I have circled the locations of the screws that are somewhat hidden from plain view (you may need a flashlight to see them).  You may also find that a smaller T-10 screwdriver is a better fit...just don't strip the screws. 


After you remove the 4 screws holding the mirror positioner in place, unplug the wiring harness from the back of the positioner.  Our 2008 has a single plug that just pulls straight out.  The 2007 has 2 plugs that just pull straight out (take note of which position is in which spot).

This is the inside off the housing without the mirror positioner.  You will use the same T-15 screwdriver to remove the 4 screws holding the mirror cap to the structural arm.  Once the 4 screws are removed, just negotiate the mirror cap upward and off of the structural arm.



Just reverse the process to install the replacement mirror cap.

This process really is pretty quick.  We switched out the mirror caps on 2 H3's in about 15 minutes.

Hope you find this helpful!




_____________________________


Come check out my GARAGE!
Post #: 1
RE: H3 - How To: Remove Mirror Caps w/Pics - 1/6/2008 10:06:43 AM   
Doc Olds


Posts: 3570
Score: 0
Joined: 7/11/2007
From: Boat Town USA (Michigan 48045)
Status: offline
KUDOS on the how to.  excellent pics.  Nice job!! 

(in reply to EarthQuakeAV)
Post #: 2
RE: H3 - How To: Remove Mirror Caps w/Pics - 1/6/2008 10:08:49 AM   
Muddydawg75


Posts: 9955
Score: 0
Joined: 3/11/2007
From: South Jersey Shore
Status: offline
Muddydawg75's photo gallery
oh yeah... I forgot to pm you and let you know I pinned this to the top.

_____________________________


Graphics by HUMMER DRIVER

"I feel sorry for people who don't drink. When they wake up in the morning, that's as good as they're going to feel all day." --Frank Sinatra

(in reply to Doc Olds)
Post #: 3
RE: H3 - How To: Remove Mirror Caps w/Pics - 1/6/2008 11:54:30 PM   
3hummers

 

Posts: 11750
Score: 0
Joined: 9/23/2007
Status: offline
Very clear and informative. Thanks

_____________________________

2006 H1 Alpha wagon
2000 H1 Slantback
1997 H1 wagon
2008 H3 Alpha

(in reply to Muddydawg75)
Post #: 4
RE: H3 - How To: Remove Mirror Caps w/Pics - 5/7/2008 4:04:38 PM   
heavyD

 

Posts: 32
Score: 0
Joined: 4/5/2008
Status: offline
Is there a part # just for the mirror caps not the entire mirror?

-Darrin

(in reply to 3hummers)
Post #: 5
RE: H3 - How To: Remove Mirror Caps w/Pics - 5/7/2008 11:30:20 PM   
SamHouseIII


Posts: 152
Score: 0
Joined: 9/25/2007
Status: offline
Cool, Thanks for the Info!!

Sam

(in reply to heavyD)
Post #: 6
Login OR Register now to post a reply to this forum topic.
Page:   [1]

 
Hummer Forums >> Hummer Lineup >> Hummer H3 >> H3 Frequently Asked Questions
Jump to:




Featured Sponsors
Advertising Info

Top 10 Posters
hummbob15828
3hummers11750
muddydawg759955
importkiller7254
blackstangs26796
hummerguy6673
trey1244596
rhill204548
h34 pleasure3735
shortbus3602

New Vendors
TSS Radio
AMSOIL - Performance Oil Technology
G-Style Hummer Accessories
K&N Engineering, Inc.

Hummer Forums .com is not affiliated with or endorsed by General Motors Corporation.