Wire for aux lights into cab
#2
Best place would be found by a SEARCH: Hummer Forums - Enthusiast Forum for Hummer Owners - Search Results
#4
Under the dash behind the steering column is a factory pass-through for the wiring harness from the engine compartment. The H3 has a double firewall so there are also two grommets there. You could also drill your own hole and install a grommet where ever you wanted. I think that there are one or two other pass-throughs as well.
#5
look where the clutch pedal would be and find a hole in one layer of the two layers. its a good place to drill a 3/4- 1 inch hole with a unibit or hole punch as i did. run wire thru a grommet or rubber hose and fill voids with putty.
youll be ready for the NEXT wires!
youll be ready for the NEXT wires!
Thread
Thread Starter
Forum
Replies
Last Post
Brent Whitfield
PRIVATE For Sale / Trade Classifieds
1
02-12-2014 06:40 PM
jasontag
PRIVATE For Sale / Trade Classifieds
2
04-26-2010 10:08 AM
mountainbiker
PRIVATE For Sale / Trade Classifieds
1
02-06-2007 05:44 AM