Hey there everyone i just got my first hummer . its a 2006 yellow h2 and i was hooking up a remote starter / alarm but the only thing left is to hook up the bypass to to passlock module . but the only problem is i cant find the darn thing can anyone help me with this.

 

Your pass lock wires are usually located in the steering column wiring going towards ignition. 3 thin wires, yellow, black &black w/yellow stripe.

Door locks may require up to 4 relays.

 

thanks ill look for them

 

There is a module that connects directly to the data bus so you dont have it rigged w/ a key stuck under the dash... Door locks shouldn't require any relays, just tap the unlock from one of the rear doors. If i remember correctly there was an issue w/ tapping the drivers door think it only unlocked itself, not all doors.

 

Can't help you as MURRAY'S installed mine but HEY AND WELCOME Fellow Pegger!!!!

 

cool another pegger

 

is there another way of telling which wires are for the passlock bypass

 

Instructions for the module I used-

http://ifar.ca/en/download/177/insta...l.rev-4.9j.pdf

 

I used to install these for circuit city back in high school. I would honestly recommend not to use the Remote Start feature. They almost cause problems several years down the road. Then it gets expensive to make repairs etc.... I was a MECPInstaller and that is my professional opinion.

 

I agree that the remote feature will cause problems in the long run